Aftermarket Lambda questions

[Tommey]

I`m about to install R32GTR ECU`s in an R33 and an R34.
Is it posible to not use the stock Lambda`s and feed a signal from the Innovate instead?
Does it have to supply signal to both inputs?
Any reason why i should not do it this way?

Thanks!

[Torque]

Yes,

That's independent of the ECU though.


You need to buy this:
http://www.innovatemotorsports.com/products/lc2.php

Or that:
http://www.ebay.co.uk/itm/151740096282? ... EBIDX%3AIT

The LC-2 includes a digital input/output, 2 full-programmable analog outputs, and is ideal for applications such as dynamo meters, data acquisition systems, standalone ECUs, and gauges.

[Matt]

Innovate units all have a narrow band O2 output, but some may need the extra cable to get it from the unit. LC1/LC2 have them by default but LM-2 for example would need an AUX cable

[boostjunkie]

I have an mtx-l have tried setting this up reduced the output signal to 0v-1v but the car hunted badly almost dieing had the correct input pin on the ecu, couldn't get any load on so couldn't drive it but I would like to eliminate the stock o2 if possible was hoping it would produce a better more consistant signal than the stock o2

[Matt]

I've read similar issues on here with the narrow band output not working that great. Not sure if it needs configuring or if its just Innovate. I just replaced my last O2 sensors with aftermarket ones